C613-50105-01 REV C Command Reference for x210 Series 610
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP
ip igmp
Overview Use this command to enable IGMP on an interface. The command configures the
device as an IGMP querier.
Use the no variant of this command to return all IGMP related configuration to the
default on this interface.
Syntax
ip igmp
no ip igmp
Default Disabled
Mode Interface Configuration for a VLAN interface.
Usage An IP address must be assigned to the interface first, before this command will
work.
Example To specify an interface as an IGMP querier, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp
Validation
Commands
show ip igmp interface
show running-config
To Next Page
Loading...
