C613-50105-01 REV C Command Reference for x210 Series 623
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP QUERY-INTERVAL
To reset the period between sending IGMP host-query messages to the default
(125 seconds) for vlan10, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# no ip igmp query-interval
Related
Commands
ip igmp query-holdtime
ip igmp query-max-response-time
ip igmp startup-query-interval
show ip igmp interface
show running-config
To Next Page
Loading...
