Allied Telesis AT-x210-9GT - Ip Igmp Snooping Fast-Leave

C613-50105-01 REV C Command Reference for x210 Series 629
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP SNOOPING FAST-LEAVE
ip igmp snooping fast-leave
Overview Use this command to enable IGMP Snooping fast-leave processing. Fast-leave
processing is analogous to immediate-leave processing. The IGMP
group-membership entry is removed as soon as an IGMP leave group message is
received, without sending out a group-specific query.
Use the no variant of this command to disable fast-leave processing.
Syntax
ip igmp snooping fast-leave
no ip igmp snooping fast-leave
Default IGMP Snooping fast-leave processing is disabled.
Mode Interface Configuration for a VLAN interface.
Usage This IGMP Snooping command can only be configured on VLAN interfaces.
Example To enable fast-leave processing on vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp snooping fast-leave
Related
Commands
show ip igmp interface
show running-config