C613-50105-01 REV C Command Reference for x210 Series 660
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
MLD SNOOPING COMMANDS
IPV
6 MLD IMMEDIATE-LEAVE
ipv6 mld immediate-leave
Overview Use this command to minimize the leave latency of MLD memberships.
Use the no variant of this command to disable this feature.
Syntax
ipv6 mld immediate-leave group-list <IPv6-access-list-name>
no ipv6 mld immediate-leave
Default Disabled
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Example The following example shows how to enable the immediate-leave feature on an
interface for a specific range of multicast groups. In this example, the router
assumes that the group access-list consists of groups that have only one node
membership at a time per interface:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld immediate-leave v6grp
awplus(config-if)# exit
Parameter Description
<IPv6-access-
list-name>
Specify a Standard or an Extended software IPv6 access-list
name that defines multicast groups in which the
immediate leave feature is enabled.
See IPv6 Software Access Control List (ACL) Commands for
supported IPv6 ACLs.
To Next Page
Loading...
