C613-50105-01 REV C Command Reference for x210 Series 68
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
Valid characters The filename and path can include characters from up to four categories. The
categories are:
1) uppercase letters: A to Z
2) lowercase letters: a to z
3) digits: 0 to 9
4) special symbols: all printable ASCII characters not included in the previous
three categories. Including the following characters:
•-
•/
•.
•_
•@
•"
•'
•*
•:
•~
•?
Do not use spaces or parentheses within filenames. Use hyphens or underscores
instead.
Syntax for
directory listings
A leading slash (/) indicates the root of the current filesystem location.
In commands where you need to specify the local filesystem’s Flash base directory,
you may use flash or flash: or flash:/. For example, these commands are all the
same:
• dir flash
• dir flash:
• dir flash:/
You cannot name a directory or subdirectory flash, nvs, usb, card, tftp, scp, sftp
or http. These keywords are reserved for tab completion when using various file
commands.
Command List •“boot config-file” on page 70
•“boot config-file backup” on page 71
•“boot system” on page 72
•“boot system backup” on page 73
•“cd” on page 74
•“copy (filename)” on page 75
To Next Page
Loading...
