C613-50105-01 REV C Command Reference for x210 Series 720
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST (STANDARD NUMBERED)
You can either create access-lists from within this command, or you can enter
access-list followed by only the number. Entering only the number moves you to
the IPv4 Standard ACL Configuration mode for the selected access-list. From there
you can configure your access-lists by using the command (access-list standard
numbered filter).
NOTE: Software ACLs will deny access unless explicitly permitted by an ACL action.
Examples To create ACL number 67 that will deny packets from subnet 172.16.10, use the
commands:
awplus# configure terminal
awplus(config)# access-list 67 deny 172.16.10.0 0.0.0.255
Alternatively, to enter the IPv4 Standard ACL Configuration mode to create the
ACL filter and deny packets from subnet 172.16.10.0 for the standard
numbered access-list 67, use the commands:
awplus# configure terminal
awplus(config)# access-list 67
awplus(config-ip-std-acl)# deny 172.16.10.0 0.0.0.255
Related
Commands
(access-list standard named filter)
show running-config
show ip access-list
To Next Page
Loading...
