Allied Telesis AT-x210-9GT - Page 722

C613-50105-01 REV C Command Reference for x210 Series 722
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST STANDARD NAMED FILTER)
Usage An ACL can be configured with multiple ACL filters using sequence numbers. If the
sequence number is omitted, the next available multiple of 10 will be used as the
sequence number for the new filter. A new ACL filter can be inserted into the
middle of an existing list by specifying the appropriate sequence number.
NOTE: The access control list being configured is selected by running the access-list
standard (named) command with the required access control list name, but with no
further parameters selected.
Software ACLs will deny access unless explicitly permitted by an ACL action.
Examples Use the following commands to add a new filter entry to access-list my-list that
will reject IP address 10.1.1.1:
awplus# configure terminal
awplus(config)# access-list standard my-list
awplus(config-ip-std-acl)# deny 10.1.1.1/32
Use the following commands to insert a new filter entry into access-list my-list
at sequence position number 15 that will accept IP network 10.1.2.0:
awplus# configure terminal
awplus(config)# access-list standard my-list
awplus(config-ip-std-acl)# 15 permit 10.1.2.0/24
Related
Commands
access-list standard (named)
show running-config
show ip access-list