C613-50105-01 REV C Command Reference for x210 Series 77
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
COPY
DEBUG
copy debug
Overview This command copies a specified debug file to a destination file.
Syntax
copy debug {<destination-name>|debug|flash|nvs|scp|tftp}
{<source-name>|debug|flash|nvs|scp|tftp}
Mode Privileged Exec
Output Figure 2-1: CLI prompt after entering the copy debug command
Related
Commands
delete debug
move debug
Parameter Description
<destination-name> The filename and path where you would like the debug
output saved. See Introduction on page 67 for valid syntax.
<source-name> The filename and path where the debug output originates.
See Introduction on page 67 for valid syntax.
Enter source file name []:
To Next Page
Loading...
