Allied Telesis AT-x210-9GT - Show Dot1 X Sessionstatistics

C613-50105-01 REV C Command Reference for x210 Series 824
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
802.1X COMMANDS
SHOW
DOT1X SESSIONSTATISTICS
show dot1x sessionstatistics
Overview This command shows authentication session statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show dot1x sessionstatistics [interface <interface-list>]
Mode Privileged Exec
Example See sample output below showing 802.1X (dot1x) authentication session
statistics for port1.0.6:
awplus# show dot1x sessionstatistics interface port1.0.6
Parameter Description
interface Specify a port to show.
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
Authentication session statistics for interface 
port1.0.6
session user name: manager
session authentication method: Remote server
session time: 19440 secs
session terminat cause: Not terminated yet