Allied Telesis AT-x210-9GT - Page 840

C613-50105-01 REV C Command Reference for x210 Series 840
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
DYNAMIC-VLAN-CREATION
To disable the Dynamic VLAN assignment feature on interface port1.0.2, use
the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth dynamic-vlan-creation
To enable the Dynamic VLAN assignment feature on authentication profile
‘student’, use the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth dynamic-vlan-creation
To disable the Dynamic VLAN assignment feature on authentication profile
‘student’, use the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# no auth dynamic-vlan-creation
Validation
Commands
show dot1x
show dot1x interface
show running-config
Related
Commands
auth profile (Global Configuration)
auth host-mode