Allied Telesis AT-x210-9GT - Description (Authentication Profile)

C613-50105-01 REV C Command Reference for x210 Series 918
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
DESCRIPTION
(AUTHENTICATION PROFILE)
description (Authentication Profile)
Overview Use this command to add a description to an authentication profile in
Authentication Profile mode.
Use the no variant of this command to remove the current description.
Syntax
description <description>
Default No description configured by default.
Mode Authentication Profile
Example To add a description to the authentication profile ‘student’, use the following
commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# description student room setting
To remove a description from the authentication profile ‘student’, use the
following commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# no description
Related
Commands
auth profile (Global Configuration)
Parameter Description
<description> Text describing the selected authentication profile.