C613-50105-01 REV C Command Reference for x210 Series 929
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
SHOW
AUTH SESSIONSTATISTICS
show auth sessionstatistics
Overview This command shows authentication session statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
Syntax
show auth sessionstatistics [interface <interface-list>]
Mode Privileged Exec
Example To display authentication statistics for port1.0.6, enter the command:
awplus# show auth sessionstatistics interface port1.0.6
Output Figure 27-3: Example output from the show auth sessionstatistics command
Parameter Description
interface Specify ports to show.
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g.
port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by
a hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
Authentication session
statistics for interface port1.0.6
session user name: manager
session authentication method: Remote server
session time: 19440 secs
session terminat cause: Not terminated yet
To Next Page
Loading...
