Allied Telesis AT-x210-9GT - Show Auth Two-Step Supplicant Brief

C613-50105-01 REV C Command Reference for x210 Series 935
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
SHOW
AUTH TWO-STEP SUPPLICANT BRIEF
show auth two-step supplicant brief
Overview This command displays the supplicant state of the two-step authentication feature
on the interface.
Syntax
show auth two-step supplicant [interface <ifrange>] brief
Mode Privileged Exec
Usage Do not mix interface types in a list. The specified interfaces must exist.
Example To display the supplicant state of the two-step authentication feature, enter the
command:
awplus# show two-step supplicant interface port1.0.6 brief
Output Figure 27-7: Example output from show auth two-step supplicant brief
Related
Commands
auth two-step enable
Parameter Description
interface The interface selected for display.
<ifrange> The interface types which can be specified as <ifrange>
• Switch port (e.g. port1.0.6)
• Static channel group (e.g. sa3)
• Dynamic (LACP) channel group (e.g. po4)
interface port1.0.6

authenticationMethod: dot1x/mac

Two-Step Authentication:
firstMethod:mac
secondMethod:dot1x
totalSupplicantNum: 1
authorizedSupplicantNum: 1
macBasedAuthenticationSupplicantNum: 0
dot1xAuthenticationSupplicantNum: 1
webBasedAuthenticationSupplicantNum: 0
otherAuthenticationSupplicantNum: 0

Interface VID Mode MAC Address Status FirstStep SecondStep
========== === ==== =========== ====== ========= ==========
port1.0.6 1 D 000b..db67.00f7 Authenticated Pass Pass