Allied Telesis AT-x210-9GT - Aaa Accounting Dot1 X

C613-50105-01 REV C Command Reference for x210 Series 947
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AAA COMMANDS
AAA
ACCOUNTING DOT1X
aaa accounting dot1x
Overview This command configures the default accounting method list for IEEE
802.1X-based authentication. The default accounting method list specifies what
type of accounting messages are sent and which RADIUS servers the accounting
messages are sent to. The default accounting method list is automatically applied
to interfaces with IEEE 802.1X-based authentication enabled.
Use the no variant of this command to disable AAA accounting for 802.1X-based
authentication globally.
Syntax
aaa accounting dot1x default {start-stop|stop-only|none} group
{<group-name>|radius}
no aaa accounting dot1x default
Default RADIUS accounting for 802.1X-based authentication is disabled by default (there
is no default server set by default).
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages will be
sent:
• group radius: use all RADIUS servers configured by radius-server host
command.
• group <group-name>: use the specified RADIUS server group configured
with the aaa group server command.
The accounting event to send to the RADIUS server is configured by the following
options:
• start-stop: sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
• stop-only: sends a stop accounting message at the end of a session.
• none: disables accounting.
Parameter Description
default Configure the default accounting method list
start-stop Sends a start accounting message at the beginning of the session
and a stop accounting message at the end of the session.
stop-only Only sends a stop accounting message at the end of the session.
none No accounting record sent.
group Use a server group
<group-name> Server group name.
radius Use all RADIUS servers.