C613-50105-01 REV C Command Reference for x210 Series 977
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AAA COMMANDS
SERVER
NAME-CHECK
server name-check
Overview This command sets the global behavior for certificate name-checking for the
RadSecProxy AAA application to on. This behavior will be used for all servers
associated with the application that do not specify a behavior on a per-server basis.
If name-checking is enabled, the Common Name portion of the subject field of the
client’s X.509 certificate must match the domain name or IP address specified in
the server (radsecproxy-aaa) command.
Use the no variant of this command to set the global behavior for certificate name
checking to off
Syntax
server name-check
no server name-check
Default Certificate name checking is on by default.
Mode RadSecProxy AAA Configuration Mode
Example Disable certificate name checking globally with the following command:
awplus# configure terminal
awplus(config)# radius-secure-proxy aaa
awplus(config-radsecproxy-aaa)# no server name-check
Related
Commands
proxy-port
radius-secure-proxy aaa
server (radsecproxy-aaa)
server trustpoint
To Next Page
Loading...
