Allied Telesis AT-x210-9GT - Show File Systems

C613-50105-01 REV C Command Reference for x210 Series 98
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
SHOW
FILE SYSTEMS
show file systems
Overview This command lists the filesystems and their utilization information where
appropriate.
Syntax
show file systems
Mode Privileged Exec
Examples To display the filesystems, use the command:
awplus# show file systems
Output Figure 2-6: Example output from the show file systems command
awplus#show file systems
Size(b) Free(b) Type Flags Prefixes S/D/V Lcl/Ntwk Avail
-------------------------------------------------------------------
63.0M 28.5M flash rw flash: static local Y
- - system rw system: virtual local -
10.0M 9.8M debug rw debug: static local Y
499.0K 431.0K nvs rw nvs: static local Y
- - tftp rw tftp: - network -
- - scp rw scp: - network -
- - sftp ro sftp: - network -
- - http ro http: - network -
- - rsync rw rsync: - network -
Table 2: Parameters in the output of the show file systems command
Parameter Description
Size (B)
Available
The total memory available to this filesystem. The units are given
after the value and are M for Megabytes or k for kilobytes.
Free (B) The total memory free within this filesystem. The units are given
after the value and are M for Megabytes or k for kilobytes.
Type The memory type used for this filesystem; one of:
flash
system
nvs
tftp
scp
sftp
http.
Flags The file setting options: rw (read write), ro (read only).