Allied Telesis AT-x210-9GT - Chapter 29: RADIUS Commands; Introduction; RADIUS Commands

29
C613-50105-01 REV C Command Reference for x210 Series 983
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RADIUS Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the device to use RADIUS servers.
Command List •“auth radius send nas-identifier” on page 984
•“auth radius send service-type” on page 985
•“deadtime (RADIUS server group)” on page 986
•“debug radius” on page 987
•“ip radius source-interface” on page 988
•“radius-server deadtime” on page 989
•“radius-server host” on page 990
•“radius-server key” on page 993
•“radius-server retransmit” on page 994
•“radius-server timeout” on page 996
•“server (Server Group)” on page 998
•“show debugging radius” on page 1000
•“show radius” on page 1001
•“show radius statistics” on page 1004
•“undebug radius” on page 1005