C613-50104-01 REV A Command Reference for x230 Series 1410
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
CLEANUP
atmf cleanup
Overview This command erases all data from NVS and all data from Flash excluding the
following:
• The current release file and its /flash/.release file
• The backup release file and /flash/.backup file
• v1 license files /flash/.configs/.swfeature.lic
• v2 license files /flash/.configs/.sw_v2.lic
It then reboots to put the device in a clean state ready to be used as a replacement
node on a provisioned port.
Syntax
atmf cleanup
Mode Privileged Exec
Usage This command is an alias to the erase factory-default command.
Example To erase data, use the command:
Node_1# atmf cleanup
This command will erase all NVS, all flash contents except for
the boot release, and any license files, and then reboot the
switch. Continue? (y/n):y
Related
Commands
erase factory-default
To Next Page
Loading...
