C613-50104-01 REV A Command Reference for x230 Series 1668
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LOCATION
CIVIC-LOCATION CONFIGURATION
location civic-location configuration
Overview Use these commands to configure a civic address location. The country parameter
must be specified first, and at least one of the other parameters must be
configured before the location can be assigned to a port.
Use the no variants of this command to delete civic address parameters from the
location.
Syntax
country <country>
state <state>
no state
county <county>
no county
city <city>
no city
division <division>
no division
neighborhood <neighborhood>
no neighborhood
street-group <street-group>
no street-group
leading-street-direction <leading-street-direction>
no leading-street-direction
trailing-street-suffix <trailing-street-suffix>
no trailing-street-suffix
street-suffix <street-suffix>
no street-suffix
house-number <house-number>
no house-number
house-number-suffix <house-number-suffix>
no house-number-suffix
landmark <landmark>
no landmark
additional-information <additional-information>
no additional-information
To Next Page
Loading...
