Allied Telesis AT-x230-28GP - Show Debugging Lldp

C613-50104-01 REV A Command Reference for x230 Series 1680
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
SHOW
DEBUGGING LLDP
show debugging lldp
Overview This command displays LLDP debug settings for specified ports. If no port list is
supplied, LLDP debug settings for all ports are displayed.
Syntax
show debugging lldp [interface <port-list>]
Mode User Exec and Privileged Exec
Examples To display LLDP debug settings for all ports, use the command:
awplus# show debugging lldp
To display LLDP debug settings for ports 1.0.1 to 1.0.6, use the command:
awplus# show debugging lldp interface port1.0.1-1.0.6
Output Figure 47-1: Example output from the show debugging lldp command
Parameter Description
<port-list> The ports for which the LLDP debug settings are shown.
LLDP Debug settings:
Debugging for LLDP internal operation is on
Port Rx RxPkt Tx TxPkt
------------------------------------
1.0.1 Yes Yes No No
1.0.2 Yes No No No
1.0.3 No No No No
1.0.4 Yes Yes Yes No
1.0.5 Yes No Yes No
1.0.6 Yes Yes Yes Yes
Table 1: Parameters in the output of the show debugging lldp command
Parameter Description
Port Port name.
Rx Whether debugging of LLDP receive is enabled on the port.
RxPkt Whether debugging of LLDP receive packet dump is enabled on the
port.
Rx Whether debugging of LLDP transmit is enabled on the port.
RxPkt Whether debugging of LLDP transmit packet dump is enabled on the
port.