C613-50104-01 REV A Command Reference for x230 Series 551
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LINK AGGREGATION COMMANDS
LACP
PORT-PRIORITY
lacp port-priority
Overview Use this command to set the priority of a device port. Ports are selected for
aggregation based on their priority, with the higher priority (numerically lower)
ports selected first.
Use the no variant of this command to reset the priority of port to the default.
Syntax
lacp port-priority <1-65535>
no lacp port-priority
Default The default is 32768.
Mode Interface Configuration
Example
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# lacp port-priority 34
Parameter Description
<1-65535> Specify the LACP port priority.
To Next Page
Loading...
