C613-50104-01 REV A Command Reference for x230 Series 959
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
QOS COMMANDS
POLICE
TWIN-RATE ACTION
Using an action of remark-transmit means that the packet will be remarked with
the values configured in the policed-dscp map. The index into this map is
determined by the DSCP in the packet.
Note that the remark-map does not only apply to red traffic. If a remark-map is
configured on the same class-map as the policer, then the remark-map will apply
to green- colored and yellow-colored traffic irrespective of the value configured on
the action parameter of the policer. So, even if action is configured to drop-red,
the remark-map will be applied to green and yellow traffic. So, the action
parameter only applies to red- colored traffic. If action is set to drop-red, then red
traffic is dropped; if action is set to remark-transmit, then the red traffic has the
action of the remark map applied to it, and is then transmitted.
Example To configure a twin rate meter measuring a minimum rate of 10 Mbps and a
maximum rate of 20 Mbps that uses the premark map to remark any
non-conforming traffic, use the commands:
awplus# configure terminal
awplus(config)# policy-map name
awplus(config-pmap)# class classname
awplus(config-pmap-c)# police twin-rate 10000 20000 1875000
3750000 action remark-transmit
Related
Commands
no police
police single-rate action
To Next Page
Loading...
