Chapter 3: Installing the Switch
42
Installing the Switch on a Table
This section contains the procedure for installing the switch on a table or
desk.
The rubber feet on the bottom of the chassis should be left on for
table installation.
Switches should not be stacked on top of one another on a table or
desktop because that could present a personal safety hazard if you
need to move or replace switches. E76
To install the chassis on a table, perform the following procedure:
1. Review “Choosing a Site for the Switch” on page 38 to verify the
suitability of the site for the switch.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Lift the switch onto the table.
4. Go to Chapter 4, “Cabling the Networking Ports” on page 49 to
connect the network cables.
To Next Page
Loading...
