XS916MX Series Installation Guide for Stand-alone Switches
47
Installing the
Switch on a Wall
To install the XS916MX series switch on a wall, perform the following
procedure:
1. Review “Choosing a Site for the Switch” on page 38 before performing
this procedure.
2. Place the unit upside down on a level, secure surface. See Figure 17.
Figure 17. Turning the Switch Upside Down
3. Using a flat-head screwdriver, remove the rubber feet from the bottom
of the switch. See Figure 18.
Figure 18. Removing the Rubber Feet
4. Attach each bracket to the switch using two screws, which should be
installed diagonally as shown in Figure 19.
.
Figure 19. Attaching the Wall Brackets
To Next Page
Loading...
