Allied Telesis AT-XS916MXT - Figure 23: Removing the Dust Cover from an SFP Transceiver; Figure 24: Positioning the SFP Handle in the Upright Position

XS916MX Series Installation Guide for Stand-alone Switches
53
5. Remove the dust cover from the transceiver, as shown in Figure 23.
Figure 23. Removing the Dust Cover from an SFP Transceiver
6. Verify the position of the handle on the SFP transceiver.
For a top slot, the handle is in the upright position, as shown in
Figure 24. For a bottom slot, the handle should be in the down
position.
Figure 24. Positioning the SFP Handle in the Upright Position
SFP Handle