Chapter 5: Powering On the Switch
58
Monitoring the Initialization Processes
It takes about one and a half minutes for the switch to initialize its
management software programs and features, and load the default
configuration. You may monitor the progress of the initialization process
by watching the switch ID LED. It displays the number “8” for the first
minute and afterwards the number “0.”
You may also monitor the bootup sequence by connecting a terminal or
computer that has a terminal emulator program to the Console port on the
master switch. The messages are given in Figure 30 here to Figure 32 on
page 60. The messages may differ slightly depending on whether your
switch is a PoE or non-PoE model.
After the switch has initialized its management software, go to
“Configuring the Switch for Stand-alone Operations” on page 61.
Figure 30. Switch Initialization Messages
Bootloader 3.1.3-devel loaded
Press <Ctrl+B> for the Boot Menu
Reading filesystem...
Loading flash:xs900-main-20151028-4.rel...
Verifying release... OK
Booting...
Starting base/first... [ OK ]
Mounting virtual filesystems... [ OK ]
______________ ____
/\ \ / /______\
/ \ \_ __/ /| ______ |
/ \ | | / | ______ |
/ \ \ / / \ ____ /
/______/\____\ \/ /____________/
Allied Telesis Inc.
AlliedWare Plus (TM) v0.0.0
Current release filename: xs900-main-20151028-4.rel
Built: Wed Oct 28 06:23:09 UTC 2015
Mounting static filesystems... [ OK ]
Checking flash filesystem... [ OK ]
To Next Page
Loading...
