Allied Telesis CentreCOM GS970M Series - Installing a GS970 M;18, GS970 M;18 PS or GS970 M;28 Switch in an Equipment Rack; Figure 34: Attaching Rack Mount Brackets to the GS970 M;18, GS970 M;18 PS or GS970 M;28 Switch

GS9790M Series Switch Installation Guide
61
Installing a GS970M/18, GS970M/18PS or GS970M/28 switch in an
equipment rack
These instructions show you how to install a GS970M/18PS, 
GS970M/18, or GS970M/28 switch in an equipment rack. The rack mount
kit is AT-RKMT-J13 and can be purchased separately from your Allied
Telesis dealer. A rack mount kit is included with your GS970M/28 switch.
To install one of these switches in a 19-inch equipment rack, follow these
steps:
1. If rubber feet are attached to the base of the switch, remove them
(
Figure 25 on page 55).
2. Attach two rack mount brackets to the sides of the switch using the six
bracket screws that come with the rack mount kit AT-RKMT-J13
(Figure 34).
FIGURE 34. ATTACHING RACK MOUNT BRACKETS TO THE GS970M/18,
GS970M/18PS
OR GS970M/28 SWITCH
M
AC Ad
dres
s
La
b
el