Allied Telesis IE340-20GP - maximum-paths

C613-50631-01 Rev A Command Reference for IE340 Series 1008
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTING COMMANDS
MAXIMUM
-PATHS
maximum-paths
Overview This command enables ECMP on your device, and sets the maximum number of
paths that each route has in the Forwarding Information Base (FIB). ECMP is
enabled by default.
The no variant of this command sets the maximum paths to the default of 4.
Syntax
maximum-paths <1-8>
no maximum-paths
Default By default the maximum number of paths is 4.
Mode Global Configuration
Examples To set the maximum number of paths for each route in the FIB to 5, use the
commands:
awplus# configure terminal
awplus(config)# maximum-paths 5
To set the maximum paths for a route to the default of 4, use the commands:
awplus# configure terminal
awplus(config)# no maximum-paths
Command
changes
Version 5.5.2-2.2: command added to x330 and GS970EMX series
Parameter Description
<1-8> The maximum number of paths that a route can have in the FIB.