Allied Telesis IE340-20GP - ip rip send-packet

C613-50631-01 Rev A Command Reference for IE340 Series 1044
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
IP
RIP SEND-PACKET
ip rip send-packet
Overview Use this command to enable sending RIP packets through the current interface.
Use the no variant of this command to disable this feature.
Syntax
ip rip send-packet
no ip rip send-packet
Default Enabled
Mode Interface Configuration for a VLAN interface.
Example To turn on packet sending on the interface vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip rip send-packet
Related
commands
ip rip receive-packet