Allied Telesis IE340-20GP - ip ospf resync-timeout

C613-50631-01 Rev A Command Reference for IE340 Series 1152
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
IP
OSPF RESYNC-TIMEOUT
ip ospf resync-timeout
Overview Use this command to set the interval after which adjacency is reset if out-of-band
resynchronization has not occurred. The interval period starts from the time a
restart signal is received from a neighbor.
Use the no variant of this command to return to the default.
Syntax
ip ospf [<ip-address>] resync-timeout <1-65535>
no ip ospf [<ip-address>] resync-timeout
Mode Interface Configuration for a VLAN interface.
Example To set the OSPF resynchronization timeout value to 65 seconds on the VLAN
interface vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip ospf resync-timeout 65
Parameter Description
<ip-address> The IP address of the interface.
<1-65535> The resynchronization timeout value of the interface in seconds.