Allied Telesis IE340-20GP - BGP and BGP4+ Commands; Introduction

30
C613-50631-01 Rev A Command Reference for IE340 Series 1301
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP and BGP4+
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
the Border Gateway Protocol for IPv4 (BGP) and for IPv6 (BGP4+).
For basic BGP and BGP4+ introduction information and configuration examples,
see the Routing_Protocol Guide.
Command List •“address-family” on page 1307
•“aggregate-address” on page 1309
•“auto-summary (BGP only)” on page 1312
•“bgp aggregate-nexthop-check” on page 1314
•“bgp always-compare-med” on page 1315
•“bgp bestpath as-path ignore” on page 1317
•“bgp bestpath compare-confed-aspath” on page 1318
•“bgp bestpath compare-routerid” on page 1319
•“bgp bestpath med” on page 1320
•“bgp bestpath med remove-recv-med” on page 1322
•“bgp bestpath med remove-send-med” on page 1323
•“bgp client-to-client reflection” on page 1324
•“bgp cluster-id” on page 1325
•“bgp confederation identifier” on page 1327
•“bgp confederation peers” on page 1328
•“bgp config-type” on page 1330
•“bgp dampening” on page 1332
•“bgp damp-peer-oscillation (BGP only)” on page 1334