Allied Telesis IE340-20GP - show debugging nsm mcast

C613-50631-01 Rev A Command Reference for IE340 Series 1776
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
SHOW
DEBUGGING NSM MCAST
show debugging nsm mcast
Overview Use this command to show the status of the NSM multicast debugging.
Syntax
show debugging nsm mcast
Mode Privileged Exec
Usage notes This command is intended for use by Allied Telesis authorized service personnel
for diagnostic purposes.
Example To show debugging for NSM multicast, use the following command:
awplus# show debug nsm mcast
Output Figure 34-1: Example output from show debug nsm mcast
Related
commands
debug nsm mcast
Command
changes
Version 5.4.7-2.1: command added
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2
awplus# show debugging nsm mcast
Debugging status:
NSM multicast vif debugging is on
NSM multicast route debugging is on
NSM multicast route statistics debugging is on
NSM multicast FIB message debugging is on
NSM multicast PIM Register message debugging is on
NSM multicast traceroute debugging is on
NSM multicast traceroute detailed debugging is on