Allied Telesis IE340-20GP - ip pim dr-priority

C613-50631-01 Rev A Command Reference for IE340 Series 1802
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM DR-PRIORITY
ip pim dr-priority
Overview Use this command to set the Designated Router priority value.
Use the no variant of this command to disable this function.
Syntax
ip pim dr-priority <priority>
no ip pim dr-priority [<priority>]
Default The default is 1. The negated form of this command restores the value to the
default.
Mode Interface Configuration for a VLAN interface.
Examples To set the Designated Router priority value to 11234 for the VLAN interface vlan2,
apply the commands as shown below:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim dr-priority 11234
To disable the Designated Router priority value for the VLAN interface vlan2, apply
the commands as shown below:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ip pim dr-priority
Related
commands
ip pim ignore-rp-set-priority
Parameter Description
<priority> Specify the Designated Router priority value, in the range 0 to
4294967294. Note that a higher value has a higher preference or
higher priority.