C613-50631-01 Rev A Command Reference for IE340 Series 1837
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
SHOW
IP PIM SPARSE-MODE NEIGHBOR
show ip pim sparse-mode neighbor
Overview Use this command to show the PIM-SM neighbor information.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip pim sparse-mode neighbor [<interface>] [<ip-address>]
[detail]
Mode Privileged Exec
Examples To show the neighbor information for all interfaces, use the command:
awplus# show ip pim sparse-mode neighbor
To show the neighbor information for vlan5, use the command:
awplus# show ip pim sparse-mode neighbor vlan5 detail
Output Figure 35-13: Example output from the show ip pim sparse-mode neighbor
command
Figure 35-14: Example output from the show ip pim sparse-mode neighbor
interface detail command
Parameter Description
<interface> Interface name. Show neighbors on an interface.
<ip-address> Show neighbors with a particular address on an interface. The IP
address entered in the form A.B.C.D.
detail Show detailed information.
Neighbor Interface Uptime/Expires Ver DR
Address Priority/
Mode
10.10.0.9 vlan2 00:55:33/00:01:44 v2 1 /
10.10.0.136 vlan2 00:55:20/00:01:25 v2 1 /
10.10.0.172 vlan2 00:55:33/00:01:32 v2 1 / DR
192.168.0.100 vlan3 00:55:30/00:01:20 v2 N / DR
Nbr 10.10.3.180 (vlan5), DR
Expires in 55 seconds, uptime 00:00:15
Holdtime: 70 secs, T-bit: off, Lan delay: 1, Override interval: 3
DR priority: 100, Gen ID: 625159467,
Secondary addresses:
192.168.30.1
To Next Page
Loading...
