C613-50631-01 Rev A Command Reference for IE340 Series 1870
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM REGISTER-RATE-LIMIT
ipv6 pim register-rate-limit
Overview Use this command to configure the rate of register packets sent by this DR, in units
of packets per second. The configured rate is per (S, G) state, and is not a system
wide rate.
Use the no variant of this command to remove the limit and reset to the default
rate limit.
Syntax
ipv6 pim register-rate-limit <1-65535>
no ipv6 pim register-rate-limit
Mode Global Configuration
Default The default is 0, as reset with the no variant, which also specifies an unlimited rate
limit.
Examples
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim register-rate-limit 3444
awplus# configure terminal
awplus(config)# no ipv6 pim register-rate-limit 3444
Parameter Description
<1-65535> Specifies the maximum number of packets that can be sent per second.
To Next Page
Loading...
