Allied Telesis IE340-20GP - ipv6 pim sparse-mode

C613-50631-01 Rev A Command Reference for IE340 Series 1880
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM SPARSE-MODE
ipv6 pim sparse-mode
Overview Use this command to enable PIM-SMv6 on an interface.
Use the no variant of this command to disable PIM-SMv6 on an interface.
Syntax
ipv6 pim sparse-mode
no ipv6 pim sparse-mode
Mode Interface Configuration for a VLAN interface.
Examples To enable PIM-SMv6 on vlan2, use the commands:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 pim sparse-mode
To disable PIM-SMv6 on vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ipv6 pim sparse-mode