Allied Telesis IE340-20GP - show ipv6 pim sparse-mode local-members

C613-50631-01 Rev A Command Reference for IE340 Series 1892
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE LOCAL-MEMBERS
show ipv6 pim sparse-mode local-members
Overview Use this command to show detailed local member information on an interface
configured for PIM-SMv6. If you do not specify an interface then detailed local
member information is shown for all interfaces configured for PIM-SMv6.
For information on filtering and saving command output, see the “Getting_Started
with AlliedWare Plus” Feature Overview and Configuration_Guide.
Syntax
show ipv6 pim sparse-mode local-members [<interface>]
Mode User Exec and Privileged Exec
Example To show detailed PIM-SMv6 information for all PIM-SMv6 configured interfaces,
use the command:
awplus# show ipv6 pim sparse-mode local-members
Output Figure 36-6: Example output from the show ipv6 pim sparse-mode
local-members command
Output Figure 36-7: Example output from the show ipv6 pim sparse-mode
local-members vlan1 command
Parameter Description
<interface> Optional Specify the interface.
awplus#show ipv6 pim sparse-mode local-members 
PIM Local membership information 

vlan1: 

(*, ff02::1:ff6b:4783) : Include 

vlan203: 

(*, ff0e:1::4) : Include 

awplus#show ipv6 pim sparse-mode local-members vlan1 
PIM Local membership information 

vlan1: 

(*, ff02::1:ff6b:4783) : Include 
