Allied Telesis IE340-20GP - auth-web idle-timeout enable

C613-50631-01 Rev A Command Reference for IE340 Series 2281
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB IDLE-TIMEOUT ENABLE
auth-web idle-timeout enable
Overview Use this command to enable the idle-timeout for client of web authentication on
the interface.
The no variant of this command to disable the idle-timeout for client of web
authentication on the interface.
Syntax
auth-web idle-timeout enable
no auth-web idle-timeout enable
Default The idle-timeout is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Example To enable the idle-timeout on an interface, use the following commands:
awplus# configure terminal
awplus(config)# interface eth1
awplus(config)# auth-web enable
awplus(config-if)# auth-web idle-timeout enable
To disable the idle-timeout on an interface, use the following commands:
awplus# configure terminal
awplus(config)# interface eth1
awplus(config-if)# no auth-web idle-timeout enable
Related
commands
auth-web enable
auth-web idle-timeout timeout