C613-50631-01 Rev A Command Reference for IE340 Series 2286
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB-SERVER BLOCKING-MODE
auth-web-server blocking-mode
Overview Use this command to enable blocking mode for the Web-Authentication server.
The blocking mode displays an authentication success or failure screen
immediately from the response result from a RADIUS server.
Use the no variant of this command to disable blocking mode for the
Web-Authentication server.
Syntax
auth-web-server blocking-mode
no auth-web-server blocking-mode
Default By default, blocking mode is disabled for the Web-Authentication server.
Mode Global Configuration
Example To enable blocking mode for the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# auth-web-server blocking-mode
To disable blocking mode for the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# no auth-web-server blocking-mode
Related
commands
auth-web-server redirect-delay-time
show auth-web-server
show running-config
To Next Page
Loading...
