Allied Telesis IE340-20GP - show auth interface

C613-50631-01 Rev A Command Reference for IE340 Series 2328
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH INTERFACE
show auth interface
Overview This command shows the status of port authentication on the specified interface.
Syntax
show auth interface <interface-list>
Mode Privileged Exec
Example To display the web-based authentication status for port1.0.4, enter the command:
awplus# show auth interface port1.0.4
If port-based authentication is not configured, the output will be
To display the port-based authentication status for port1.0.4, enter the command:
awplus# show auth interface port1.0.4
Parameter Description
<interface-list> The interfaces to display information about. An interface-list
can be:
•a VLAN (e.g. vlan2)
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces separated by a hyphen
(e.g. port1.0.1-port1.0.3)
• a comma-separated list (e.g. port1.0.1,
port1.0.3-port1.0.4). Do not mix interface types in a list.
% Port-Control not configured on port1.0.4