Allied Telesis IE340-20GP - show auth two-step supplicant brief

C613-50631-01 Rev A Command Reference for IE340 Series 2336
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH TWO-STEP SUPPLICANT BRIEF
show auth two-step supplicant brief
Overview This command displays the supplicant state of the two-step authentication feature
on the interface.
Syntax
show auth two-step supplicant [interface <interface-list>]
brief
Mode Privileged Exec
Usage notes Do not mix interface types in a list. The specified interfaces must exist.
Example To display the supplicant state of the two-step authentication feature, enter the
command:
awplus# show two-step supplicant interface port1.0.2 brief
Output Figure 44-8: Example output from show auth two-step supplicant brief
Parameter Description
interface The interface selected for display.
<interface-
list>
The interfaces to display information about. An interface-list can be:
• a VLAN (e.g. vlan2)
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces separated by a hyphen (e.g.
port1.0.1-port1.0.3)
• a comma-separated list (e.g. port1.0.1, port1.0.3-port1.0.4). Do not
mix interface types in a list.
interface port1.0.2

authenticationMethod: dot1x/mac

Two-Step Authentication:
firstMethod:mac
secondMethod:dot1x
totalSupplicantNum: 1
authorizedSupplicantNum: 1
macBasedAuthenticationSupplicantNum: 0
dot1xAuthenticationSupplicantNum: 1
webBasedAuthenticationSupplicantNum: 0
otherAuthenticationSupplicantNum: 0

Interface VID Mode MAC Address Status FirstStep SecondStep
========== === ==== =========== ====== ========= ==========
port1.0.8 1 D 000b..db67.00f7 Authenticated Pass Pass