Allied Telesis IE340-20GP - secure trustpoint (ldap-server)

C613-50631-01 Rev A Command Reference for IE340 Series 2422
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LIGHTWEIGHT DIRECTORY ACCESS PROTOCOL (LDAP) COMMANDS
SECURE
TRUSTPOINT (LDAP-SERVER)
secure trustpoint (ldap-server)
Overview Use this command to link a preconfigured trustpoint to the LDAP server
configuration. The trustpoint must be the LDAP server certificate and is required to
successfully connect to the LDAP server when secure mode is enabled.
Use the no variant of this command to remove a trustpoint from an LDAP server.
Syntax
secure trustpoint <trustpoint>
no secure trustpoint
Default Not set
Mode LDAP Server Configuration
Example To set the trustpoint to Trustpoint1 for the LDAP server called ‘Server1’, use the
commands:
awplus# configure terminal
awplus(config)# ldap server Server1
awplus(config-ldap-server)# secure trustpoint Trustpoint1
To remove the trustpoint from ‘Server1’, use the commands:
awplus# configure terminal
awplus(config)# ldap server Server1
awplus(config-ldap-server)# no secure trustpoint
Related
commands
host (ldap-server)
ldap-server
port (ldap-server)
secure cipher (ldap-server)
secure mode (ldap-server)
Command
changes
Version 5.5.2-1.1: command added
Parameter Description
<trustpoint> The name of the trustpoint used for LDAP secure mode