Allied Telesis IE340-20GP - show radius dynamic-authorization counters

C613-50631-01 Rev A Command Reference for IE340 Series 2453
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RADIUS COMMANDS
SHOW
RADIUS DYNAMIC-AUTHORIZATION COUNTERS
show radius dynamic-authorization
counters
Overview Use this command to display the Dynamic Authorization message counters. It
shows the count of sent and received messages, as well as a count of any error
messages.
Syntax
show radius dynamic-authorization counters
Mode Privileged Exec
Example To display the Dynamic Authorization message counters, use the following
command:
awplus# show radius dynamic-authorization counters
Output Figure 47-4: Example output from show radius dynamic-authorization
counters
awplus#show radius dynamic-authorization counters

RADIUS Dynamic Authorization packet counters
--------------------------------------------
Received:
Disconnect request : 9
CoA request : 6

Sent:
Disconnect ACK : 4
CoA ACK : 0
Disconnect NAK : 2
CoA NAK : 6

Dropped:
Duplicate packet : 2
Expired packet : 1
Error-cause:
Unsupported attribute : 0
Missing attribute : 0
Invalid request : 0
NAS ID mismatch : 0
No session context found : 3

Errors:
Unknown message type : 0
Unknown client : 0
Bad attribute : 0
Bad authenticator : 0
Malformed packet : 0