Allied Telesis IE340-20GP - show ip dhcp-relay

C613-50631-01 Rev A Command Reference for IE340 Series 3133
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
SHOW
IP DHCP-RELAY
show ip dhcp-relay
Overview This command shows the configuration of the DHCP Relay Agent on each
interface.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip dhcp-relay [interface <interface-name>]
Mode User Exec and Privileged Exec
Example To display the DHCP Relay Agent’s configuration on the interface vlan2, use the
command:
awplus# show ip dhcp-relay interface vlan2
Output Figure 59-3: Example output from the show ip dhcp-relay command
Related
commands
ip dhcp-relay agent-option
ip dhcp-relay agent-option checking
ip dhcp-relay information policy
ip dhcp-relay maxhops
ip dhcp-relay server-address
Parameter Description
<interface-name> Name of a specific interface. This displays the DHCP
configuration for the specified interface only.
DHCP Relay Service is enabled

vlan2 is up, line protocol is up
Maximum hop count is 10
Insertion of Relay Agent Option is disabled
Checking of Relay Agent Option is disabled
The Remote Id string for Relay Agent Option is 0000.cd28.074c
Relay information policy is to append new relay agent 
information
List of servers : 192.168.1.200