Allied Telesis IE340-20GP - lldp faststart-count

C613-50631-01 Rev A Command Reference for IE340 Series 3219
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
LLDP
FASTSTART-COUNT
lldp faststart-count
Overview Use this command to set the fast start count for LLDP-MED. The fast start count
determines how many fast start advertisements LLDP sends from a port when it
starts sending LLDP-MED advertisements from the port, for instance, when it
detects a new LLDP-MED capable device.
The no variant of this command resets the LLDPD-MED fast start count to the
default (3).
Syntax
lldp faststart-count <1-10>
no lldp faststart-count
Default The default fast start count is 3.
Mode Global Configuration
Examples To set the fast start count to 5, use the command:
awplus# configure terminal
awplus(config)# lldp faststart-count 5
To reset the fast start count to the default setting (3), use the command:
awplus# configure terminal
awplus(config)# no lldp faststart-count
Related
commands
show lldp
Parameter Description
<1-10> The number of fast start advertisements to send.