Allied Telesis IE340-20GP - show udld port

C613-50631-01 Rev A Command Reference for IE340 Series 774
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
SHOW
UDLD PORT
show udld port
Overview Use this command to display UDLD port status and configuration settings.
Syntax
show udld port [<interface-name>] [detail]
Mode Privileged Exec
Example To show UDLD information for all ports, use the command:
awplus# show udld port
To show detailed UDLD information for port1.0.1, use the command:
awplus# show udld port port1.0.1 detail
Output Figure 18-5: Example output from show udld port
Figure 18-6: Example output from show udld port port1.0.1 detail
Related
commands
udld port
udld port disable
udld enable
Parameter Description
<interface-name> Show UDLD information for a specified interface.
detail This option provides a greater level of detail.
awplus#show udld port
Port Status Mode Directional-State
------------ -------- ---------- -----------------
port1.0.1 Enabled Aggressive Bidirectional
port1.0.2 Disabled Normal -
awplus#show udld port port1.0.1 detail
[port1.0.1]
Status : Enabled
Mode : Aggressive
Directional-State: Bidirectional
Operational-State: Advertisement - single neighbor detected

Neighbors:
Device-ID Port-ID Device-Name Directional-State
------------ ------------ ---------------- -----------------
0000F4272DA2 port2.0.1 awplus Bidirectional