Allied Telesis Rapier i AT-RP16Fi/SC - Appletalk

108 Rapier Switch User Guide
Software Release 2.6.1
C613-02025-00 REV C
Figure 26: Example output from the SHOW IPX CIRCUIT command.
AppleTalk
AppleTalk is enabled with a special feature license. To obtain a special feature license
contact an Allied Telesyn authorised distributor or reseller.
To create an AppleTalk port (interface) associated with the admin VLAN, use
the command:
ADD APPLE PORT INTERFACE=
vlan11
To display information about the ports configured for AppleTalk (Figure 27 on
page 109), use the command:
SHOW APPLE PORT
IPX CIRCUIT information
Name ......................... Circuit 1
Status ....................... enabled
Interface .................... vlan11 (802.3)
Network number ............... c0e7230f
Station number ............... 0000cd000d26
Link state ................... up
Cost in Novell ticks ......... 1
Type20 packets allowed ....... no
On demand .................... no
Spoofing information
Keep alive spoofing .......... no
SPX watch dog spoofing ....... no
On SPX connection failure .... UPLINK
On end of SPX spoofing ....... UPLINK
RIP broadcast information
Change broadcasts ............ yes
General broadcasts ........... yes
General broadcast interval ... 60 seconds
Maximum age .................. 180 seconds
SAP broadcast information
Change broadcasts ............ yes
General broadcasts ........... yes
General broadcast interval ... 60 seconds
Maximum age .................. 180 seconds
Filter information
Filters ...................... none