Getting Started with the Graphical User Interface (GUI) 31
Software Release 2.6.1
C613-02025-00 REV C
10. Configure an IP interface to run SSL over
To configure an IP interface that SSL will be run over, first enable IP using
the command:
ENABLE IP
To make VLAN1 the IP interface, and 172.30.1.105 the interface’s IP address,
use the command:
ADD IP INTERFACE=vlan1 IP=172.30.1.105
To add an IP route on this interface with a next hop of 172.30.1.254, use the
command:
ADD IP ROUTE=0.0.0.0 INTERFACE=vlan1 NEXT=172.30.1.254
For this example to succeed, you would have to log in as “cipher” rather than “manager”
when connecting to the switch with a web browser.
System Status
The GUI opens to display the System Status page. Figure 6 points out key
information contained on the page.
Figure 6: The System Status page
Model name
Help, Save and Exit
Sidebar menu
System status
Port status
Software release
To Next Page
Loading...
