Allied Telesis SwitchBlade x3100 Series - Set System Timezone

Configuring SNTP Introduction
1-83
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
SET SYSTEM TIMEZONE
Syntax
SET SYSTEM TIMEZONE [ { EASTERN | CENTRAL | MOUNTAIN | PACIFIC |
ALASKAN | HAWAIIAN | CUSTOM UTCOFFSET={ + | -hh:mm }
[ DSTSTART=nth.weekday.month [ /hh:mm:ss ]
DSTEND=nth.weekday.month [ /hh:mm:ss ]
DSTUTCOFFSET={ + | -hh:mm } ] } ] [ DST={ ON | OFF } ]
Description Sets the timezone. There is support for Time-zones and Daylight Saving Time (DST) on
the SBx3112. With this feature the SBx3112-based times correctly reflect current local
time and whether DST is in effect if desired. Standard North American Time-zones and
their DST settings (start and end date/time and UTC offset) are supported. The user may
specify a custom time-zone with a start and end date/time and UTC offset for DST.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
TIMEZONE Allows the user to specify one of the pre-defined North
American DST time-zone settings:
(DST UTC: -4:00, Standard Time: -5:00) Eastern Time
(EDT)
(DST UTC: -5:00, Standard Time: -6:00) Central Time
(CDT)
(DST UTC: -6:00, Standard Time: -7:00) Mountain Time
(MDT)
(DST UTC: -7:00, Standard Time: -8:00) Pacific Time
(PDT)
(DST UTC: -8:00, Standard Time: -9:00) Alaska Time
(AKDT)
The standard US time-zone DST start and end date/
time is defined as M03.02.00/02:00:00 and M11.01.00/
02:00:00 respectively.
EASTERN
CUSTOM
UTCOFFSET
Specifies a value (hour and minutes) to be used as the
UTC offset. The offset can be any value between -23:59
and +23:59 (e.g., +5:45).