Allied Telesis SwitchBlade x3100 Series - Show Poe Interface

Configuring the GE24POE Card Configuration Guidelines
Software Reference for SwitchBlade x3100 Series Switches (Power over Ethernet (PoE))
3-16
SHOW POE INTERFACE
Syntax
SHOW POE INTERFACE [ ={ type:id-range | id-range | ifname-list |
ALL } ] [ FULL ]
Description Displays the PoE attributes and settings for one or more interfaces.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example When a specific interface is included, the SHOW POE INTER-
FACE command shows the main attributes for the specified
interface. With the FULL option, this command shows the con-
figuration options and the actual status.
officer SEC>> SHOW POE INTERFACE=1.*,2.0
--- POE Power Status ---
PoE POE
Interface State Priority Limit Power Status Class Actual
--------- -------- -------- ----- -------------- ---------- ----------
1.0 Disabled Low 7.0W Disabled 2 (7W) 0W
1.1 Enabled High CLASS Powered 3 (15.4W) 8.7W
1.2 Enabled Low 15.0W No PD Detected - 0W
1.3 Enabled Critical 10.0W Fault Present 0 (15.4W) 0W
1.4 Enabled Critical 5.5W Powered 2 (7W) 6.4W
1.5 Enabled High 5.0W Disabled 4 (30W) 0W ...
2.0 Enabled High CLASS Disabled - 0W
officer SEC>> SHOW POE INTERFACE=1.1 FULL
--- POE Power Status ---
Interface............................. 1.0
POE State............................. Enabled
Priority.............................. Low
Power Limit........................... CLASS
Actual
Power Status........................ Powered
Class............................... 3 (15.4W)
Power............................... 4.3W
Voltage............................. 50.1V
Current............................. 86mA
Option Description Default Value
INTERFACE A logical representation of one or more physical ports
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all applicable interfaces in the system
FULL Shows full information for the specified command.